Removal & Installation
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 BMW Z3, 2002 BMW M3, 2002 BMW M Roadster, 2002 BMW M Coupe, and 2002 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- On all models except Z3 and M coupe and roadster, remove rear seat. Remove air bag control unit mounting screws. Disconnect electrical connectors and remove control unit from vehicle. On Z3 and M coupes and roadsters, remove center console, disconnect electrical connectors, remove air bag control unit screws and remove control unit.
- To install, reverse removal procedure. Ensure arrow on top of air bag control unit points toward front of vehicle. Tighten air bag control unit mounting screws to specification. See TORQUE SPECIFICATIONS . NEW air bag control units must be re-encoded using proprietary BMW DIS/MoDiC tester. Activate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .