Drive Axle Shafts (Rear, 2 Wheel Drive Models): Removal
WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2006 BMW M3, 2006 BMW 330Ci, 2006 BMW 325Ci, 2005 BMW M3, and 2005 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The large collar (hub) nut securing axle to hub is very tight, and the axle is press-fit into wheel drive flange. Removing axle from wheel drive flange, installing it, and torquing it properly may require special tools.
- Raise, support vehicle and remove rear wheel.
- On some vehicles, it is necessary to remove rear exhaust.
- Remove dust cap from center of hub.
- Remove collar (hub) nut retaining plate and discard. See Fig 1.
- Remove the 6 inner CV joint-to-differential final drive flange bolts. Separate inner CV joint from final drive flange and support axle shaft using a piece of wire attached to underside of body. DO NOT allow axle shaft to hang freely to prevent damage to outer CV joint.
- Secure special tool with 2 wheel studs and press axle out of wheel drive flange. See Figure.
- Remove axle shaft from vehicle.