51 13 402 Removing and installing handle strip (on trunk lid)
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 325Ci, 2005 BMW 325xi, 2005 BMW 325i, 2005 BMW 325Ci, and 2004 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.
Version from 10/99:
Remove panel for rear lid in rear area. See 51 49 000 Removing and installing or replacing trim for trunk lid
Feed out wiring harness (2) in direction of arrow from bracket (1).
Disconnect plug connection (3).
Release screws (1) and withdraw handle strip (2) somewhat.
Version from 10/99:
Remove strip handle (2).
Installation:
Tightening torque, refer to 51 13 4AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 325I, CI & XI - E46 .
Check function.
Version up to 10/99:
Disconnect plug connection (1) and remove handle strip (2).
Installation:
Tightening torque, refer to 51 13 4AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 325I, CI & XI - E46 .
Check function.