11 22 500 Removing and installing or replacing flywheel (M52 / S52 / M52TU / M54 / S54)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2006 BMW 325Ci, 2005 BMW 325xi, 2005 BMW 325i, 2005 BMW 325Ci, and 2004 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

NOTE: For special tools, refer to ENGINE - SPECIAL TOOLS .

11 2 170
1. (clutch removed)

Lock flywheel with special tool 11 2 170.

Fig 1: Identifying Special Tool 11 2 170

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws and remove flywheel.

Fig 2: Unfastening Screws And Removing Flywheel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check dowel sleeve for damage and correct installation position.

Fig 3: Checking Dowel Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position of dowel sleeve (1) in dual-mass flywheel is identified by two notches next to associated bolt hole.

Fig 4: Positioning Of Dowel Sleeve In Dual-Mass Flywheel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean thread and install new micro-encapsulated screws.

Fig 5: Installing New Micro-Encapsulated Screws
Courtesy of BMW OF NORTH AMERICA, INC.
Tightening torque, refer to 11 22 1AZ in ENGINE - TIGHTENING TORQUES .