51 12 051 Removing And Installing/Replacing Carrier For Rear Bumper Trim (M3, M3 CSL/Lightweight Design)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2003 BMW M3, and 2002 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Foam part must be replaced when center section of bumper (carrier) is removed.
Drill out blind rivet (1) and remove grounding cable (2).
Release plastic screws (1).
Installation:
Observe tightening torque, (1.2 N.m.)
Release metal screws (2).
Remove center section of bumper (carrier) (3).
Release plastic screws (1).
Installation:
Observe tightening torque 1.2 N.m.
Remove foam part (2).