LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> M4 2D Convertible, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Body Equipment - Repair) >> Rear Bumper >> 51 12 001 Replacing Rear Bumper (Convertible/Coupe)

51 12 001 Replacing Rear Bumper (Convertible/Coupe)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2003 BMW M3, and 2002 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Replacing Rear Bumper Center Section (Carrier) (51 12 011): 

Remove complete rear bumper. Refer to 51 12 000 REMOVING AND INSTALLING COMPLETE REAR BUMPER ,

Convertible with TV only:

Remove TV bumper antenna.

Release expansion rivets (1) and remove bumper center section (2) (carrier).

NOTE: Shock absorbers are not on carrier.
Fig 1: View Of Expansion Rivets
G03118761Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Make sure nut (1) is properly fitted in carrier (2).

Fig 2: Identifying Retaining Nut
G03118762Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: The work for "Replacing rear bumper center section (carrier)" (51 12 011) ends here.

Replacing Rear Bumper Trim (51 12 157) And Replacing Rear Bumper (51 12 001): 

Remove reflecting tail light from rear bumper. Refer to 63 14 120 REMOVING AND INSTALLING/REPLACING REFLECTING TAIL LIGHT ON REAR BUMPER (COUPE, CONVERTIBLE) .

Unclip cover (2) for towing attachment from opening (1).

Lift out retaining strap (3) and remove cover (2).

Fig 3: Locating Retaining Strap
G03118763Courtesy of BMW OF NORTH AMERICA, INC.