64 53 510 Removing and installing / replacing drier flask for air conditioner

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A/C system is drawn off.

Follow instructions for dryer bottle replacement.

M3 only:

Remove right headlight.

All except M3:

Remove fluid reservoir for windshield washer system. See 64 53... Notes on replacing drier bottle or drier insert

All:

Unfasten screws.

Detach pressure and suction pipes towards top.

NOTE: Provide pressure and suction pipes with plugs if A/C system remains open for longer than one hour.

Installation:

Replace sealing rings.

Fig 1: Removing Fluid Reservoir For Windshield Washer System

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Fig 2: Unfastening Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Feed out wheel arch under trim.

Fig 3: Removing Wheel Arch Under Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen bolts.

Pull out drier bottle towards bottom.

NOTE: In event of warranty application, seal line openings with plugs of new drier bottle.

Fig 4: Removing Drier Bottle Towards Bottom

Courtesy of BMW OF NORTH AMERICA, INC.