61 62 030 Removing and installing/replacing wiper arm on rear window

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.

Spread internal catches (2) as illustrated and remove cover cap (1) in direction of arrow.

Fig 1: Removing Cover Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Catches (1) and mounts (2) of cover cap (3) must not be damaged.

Fig 2: Identifying Catches & Mounts Of Cover Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Set wiper arm (1) upwards.

Release nut (2) and remove wiper arm (1).

Installation:

Observe tightening torque. Refer to GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE .

Fig 3: Removing Wiper Arm
Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Wiper motor must be in end position.
Adjust measurement (A) between wiper arm and rear window edge.
Measurement (A): 12 mm

Fig 4: Identifying Dimension Between Wiper Arm & Rear Window Edge
Courtesy of BMW OF NORTH AMERICA, INC.