11 65 Turbocharger
TIGHTENING TORQUE SPECIFICATION (CHARGER WITH CONTROL)
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Exhaust turbocharger to cylinder head | S55 | M7 | Replace flange nut. SEE REPAIR INSTRUCTIONS . | |
| 1. Joining torque 1 to 9/10 | 12 Nm | |||
| 2. Centering pin | 90° | |||
| 3. Final torque 2 to 9/10 | 18 Nm | |||
| 2AZ Heat shield/retaining plate to crankcase/cylinder head | S55 | M6x16 10 | Nm | |
| 3AZ Wastegate valve controller to exhaust turbocharger | S55 | M4 | 2.5 Nm | |
| 4AZ Wastegate valve actuator linkage lock nut | S55 | Replace adjusting and lock nut | 6 Nm | |