11 41 Engine Oil Pump
TIGHTENING TORQUE SPECIFICATION (OIL PUMP WITH STRAINER AND MOTOR)
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Oil pump to lower section of crankcase (bedplate) | S55 | M8x123 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. Jointing torque Angle of rotation |
10 Nm 180° |
| S55 | M8x31 M8x37 |
Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. Jointing torque Angle of rotation |
10 Nm 90° |
|
| 2AZ Intake pipe with oil deflector to crankcase lower section (bedplate) | S55 | M6x30 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. Jointing torque Angle of rotation |
4 Nm 100° |
| 3AZ Oil suction pump to lower section of crankcase (bedplate) | S55 | M6x40 | 10 Nm | |
| 4AZ Suction pipe, right, to oil deflector suction pipe | S55 | M6x40 | 10 Nm | |
| 5AZ Suction pipe, left, to oil pump | S55 | M6x16 | 10 Nm | |
| 6AZ Reverse exhaust turbocharger suction pipe to oil deflector | S55 | M6x16 | 10 Nm | |
| 7AZ Chain module to crankcase and oil pump | S55 | M6x16 | 10 Nm | |
| 8AZ Hydraulic valve of oil pump to crankcase | S55 | M6x16 | 10 Nm | |
| 9AZ Sprocket to oil pump | S55 | M8 | Jointing torque Angle of rotation |
20 Nm 45° |
| 10AZ Chain tensioner to crankcase | S55 | M6x28 | 10 Nm |