11 13 Engine Oil Pan
TIGHTENING TORQUE SPECIFICATION (OIL PAN)
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Oil drain plug to magnesium oil sump. | S55 | M16x1.5 | Replace screw with sealing ring. | 20 Nm |
| 1AZ Oil drain plug on aluminium oil sump. | S55 | M12x1.5 | Replace sealing ring. | 25 Nm |
| 2AZ Oil sump (magnesium) to lower section of crankcase. | S55 | M8x26 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque Angle of rotation |
8 Nm 60° |
| 3AZ Oil sump (aluminium) to crankcase lower half. | S55 | M8x92 M8x112 |
Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Compliance with jointing torque and angle of rotation is absolutely mandatory Jointing torque Angle of rotation |
8 Nm 180° |
| 4AZ Magnesium oil sump cover | S55 | M6x16 | Replace screw. | 8 Nm |
| 5AZ Transmission to oil sump. | S55 | M8x50 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Compliance with jointing torque and angle of rotation is absolutely mandatory Jointing torque Angle of rotation |
4 Nm 100° |
| 6AZ Oil level sensor to oil sump. | S55 | M6 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Compliance with jointing torque and angle of rotation is absolutely mandatory Jointing torque Angle of rotation |
4 Nm 100° |