Rinse transmission oil cooler and lines of dual-clutch transmission
Special tools required:
- 17 2 018
- 17 2 019
Installing a new or replacement transmission.
Procedure:
Double dual-clutch transmission removed.
Connect the respective adapters to all oil pipes leaving the double TCT (see description below).
Use quick-release coupling to connecting line 17 2 019 from oil dispenser unit.
Use quick-release coupling to connect drain line 17 2 018.
Hold and direct open end of drain line into a suitable drip tray.
Using oil dispenser unit, flush approx. 1 liter of approved transmission fluid through oil lines and transmission oil cooler.
Reposition quick-release couplings.
Flush oil lines/transmission oil cooler in opposite direction with approx. 1 liter of approved transmission fluid.
Disconnect quick-release couplings.
Remove adapter.
Do not reuse under any circumstances.
Press hydraulic lines (1) into adapters (2).
Slide clamping bracket (3) into guides and secure with screw (4).
Arrangement of flushing devices for TCT
- Transmission-oil cooler with lines
- Oil dispenser unit
17 2015 Connection for oil dispenser unit (2), manufacturer: Deutsche Tecalemit or
17 2016 Connection for oil dispenser unit (2), manufacturer: Horn
17 2017 quick-release coupling (2 pieces)
17 2019 Hose to oil dispenser unit (2)
- Oil drip tray
17 2 018 Hose to oil drip tray (3)
- Adapter with clamping bracket
17 2 060 Adapter with clamping bracket for aluminium lines and steel lines with aluminium connection (line diameter 12 mm) TCT for N54 engine
17 2 070 Adapter with clamping bracket (line diameter 15 mm) for S65 TCT engine