Removing and installing glass slide/tilt sunroof panel (M4 Coupe)
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Necessary preliminary tasks:
- Remove both GAITERS .
Release left and right screws (1).
Remove glass slide/tilt sunroof panel towards top.
Installation note:
Apply Loctite to screws.
ADJUST glass slide/tilt sunroof panel.
Tightening torque 54 12 01AZ .
INITIALIZE glass slide/tilt sunroof.