Removing and installing the driver's or front passenger's seat (CFRP bucket seat) (GTS only)

Necessary preliminary work: 

• Disconnect BATTERY NEGATIVE CABLE .

Observe safety information on HANDLING AIRBAG MODULES AND PYROTECHNICAL SEAT BELT TENSIONERS .

Unclip cover (1).

Installation note: 

Replace cover (1) after each disassembly.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 72 11 2AZ .

Feed out seat belt from front seat.

Installation note: 

End fitting is coded against incorrect assembly.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Feed seat belt (1) in the marked area as shown through the front seat.

Courtesy of BMW OF NORTH AMERICA, INC.

Equipment specification with six point seat belt:

Remove seat cushion (1).

Feed out seat belt (2) from the front seat.

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust front seat fully backwards and down.

Release screws (1).

Tightening torque 52 10 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust front seat fully forwards and up.

Release screws (1).

Tightening torque 52 10 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect connector (1).

Carefully lift out front seat with the assistance of a second person.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure the limit positions of the forward/back adjustment (1) are installed correctly.

The limit position of the forward/back adjustment (1) must be installed on both of the rails as shown, install after if applicable.

Tightening torque 52 10 4AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

• Carpet must not get between seat rails and floor panel in area of attachment points (groaning noises)
• Insert all screws loose to avoid twisting
• Tighten down all screws to specified torque

  Tightening torque 52 10 1AZ .