Removing and installing front seat, driver's side (Except M4 GTS)
Necessary preliminary work:
- Disconnect BATTERY NEGATIVE CABLE .
CAUTION:
The side airbag is integrated in the front seat.
Improper handling may trigger the side airbag and as a result cause injuries.
Observe safety information on HANDLING AIRBAG MODULES AND PYROTECHNICAL SEAT BELT TENSIONERS .
Adjust front seat fully backwards and down.
Release screws (1).
Installation note:
Replace screws.
Tightening torque 52 10 1AZ .
Adjust front seat fully forwards and up.
Release screws (1).
Installation note:
Replace screws.
Tightening torque 52 10 1AZ .
Unlock and disconnect connector (1).
CAUTION:
Cover entrances with protective covers (risk of damage!)
Carefully lift out front seat with the assistance of a second person.
WARNING:
When carrying out further work on the front seat, it is absolutely imperative to observe the safety information on HANDLING AIRBAG MODULES AND PYROTECHNICAL SEAT BELT TENSIONERS
.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Installation note:
- Carpet must not get between seat rails and floor panel in area of attachment points (groaning noises)
- Insert all screws loose to avoid twisting
- Replace all screws and tighten to the specified torque
Tightening torque 52 10 1AZ .