Removing and installing/replacing support for front bumper panel (M4 Coupe, M4 Convertible)
Necessary preliminary work:
- Remove front BUMPER PANEL .
- Remove impact absorber from support
Version with active pedestrian protection:
- Remove impact absorber from support
A damaged impact absorber must not be reused.
Version with ACC:
Release screws/blind rivet (1).
Installation note:
Blind rivet nuts and associated screws are used as repair solution for defective threads or installed blind rivet.
Adhere to the NOTES on mounting blind rivet nuts.
Only F82 GTS:
Release screw (1) and remove holder (2).
Tightening torque 51 11 6AZ .
Replacement:
Rework SUPPORT .
Release screws (1) on left/right.
Tightening torque 51 11 4AZ .
Remove support (2) towards front.