51 47 Floor-Trunk-Engine Compartment-Trim Panel
TIGHTENING TORQUE SPECIFICATION (FLOOR-LUGGAGE COMPARTMENT-ENGINE COMPARTMENT TRIM PANEL)
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Lashing eye to body | F20/F21/F22/F23/F30/F31/F32/F33/F34/F35/F36/F45/F46/F48/F49/F80/F82/F83/F87 | 19 Nm | ||
| 2AZ Fitting, load area net to body (roof) | F20/F21 | 6 Nm | ||
| F31 | M6 / M8 | 7.6 Nm / 15 Nm | ||
| 3AZ Holder, roller cover for luggage compartment/load area net to body (luggage compartment) | F31 | M8 | 15 Nm | |
| 4AZ Cover, mounting load area net | F31 | 2.6 Nm | ||
| 5AZ Lashing rail to side member | F34 | 19 Nm | ||
| 6AZ Pin (from luggage compartment wheel arch trim panel) to side member | F48/F49 | 1 Nm | ||
| 7AZ Luggage compartment well to side of insert | F48/F49 | 1 Nm |
TIGHTENING TORQUE SPECIFICATION
| Shelf on body | |
| Plastic nut | 3 Nm |
| Underbody protection/underbody planking/heat insulation | |
| Screw not metric thread | 3 Nm |
| Screw M6 | 8.8 Nm |
| Nut | 2.5 Nm |
| Underbody protection front | |
| Screw not metric thread | 3 Nm |
| Screw M6 | 8.8 Nm |
| Nut | 2.5 Nm |