Adjusting rear lid lock (M4 Convertible)

Prerequisite:

Rear lid must be correctly adjusted to fit; if necessary, ADJUST REAR LID .

For ideal adjustment, refer to BODY GAP DIMENSIONS .

NOTE: The operation is shown on the left side; proceed in the same way for the right side.

Release clamps (1).

Feed out trim panel (2) in direction of arrow.

Installation note:

If necessary, replace faulty clips (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1) until striker (3) can be moved.

Move striker (3) in direction of arrow.

Tighten down screws (1).

Tightening torque 51 24 2AZ .

Check alignment of tailgate and striker, readjust if necessary.

If necessary, remove supports (2) or insert additional ones.

Courtesy of BMW OF NORTH AMERICA, INC.