2300 Manual Transmission
23 00 TRANSMISSION IN GENERAL - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Transmission to engine (Aluminium screws/bolts are not magnetic). | Replace aluminium screws. | |||
| Jointing torque and angle of rotation must be observed without fail. | ||||
| N55 | M12 | Jointing torque Angle of rotation | 25 Nm 130° |
|
| N55/N47/B47/N20/S55/B58 | M8 | Steel screw | 19 Nm | |
| N55/N47/B47/S55/B58 | M12 | Steel screw | 66 Nm | |
| N55 | M10 | Steel screw | 38 Nm | |
| N20/S55 | M10 | Steel screw | 56 Nm | |
| Steel screws with Torx head | I-transmission | M8 | 19 Nm | |
| I-transmission | M10x40-8.8 | 38 Nm | ||
| I-transmission | M10x50-10.9 | 56 Nm | ||
| I-transmission | M12 | 66 Nm | ||
| 2AZ Oil drain plug/oil filler plug | K transmission (without S55) | Hexagon socket | 40 Nm | |
| K transmission (only S55) | Hexagon socket | 43±4 Nm | ||
| I-transmission | Hexagon socket | 43±4 Nm | ||
| I-transmission | M12x1.5 | 25 Nm | ||
| I-transmission | M18x1.5 | Steel screw without seal | 45 Nm | |
| 3AZ Cover plate to transmission | I-transmission | 7.6 Nm |
| Holder for underbody protection | |
| 3 Nm | |