2800 Dual-Clutch Transmission (DCT/DKG)
28 00 TRANSMISSION IN GENERAL - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| Steel Torx screw | GS7D36SG | M8x50 | 19 Nm | |
| GS7D36SG | M10 | 38 Nm | ||
| GS7D36SG | M12 | 66 Nm | ||
| Aluminium screws/bolts are not magnetic N54/N55 | GS7D36SG | Replace screws Jointing torque and angle of rotation must be observed without fail | ||
| GS7D36SG | M12 | Jointing torque Angle of rotation | 25 Nm 130° |
|
| Aluminium screws/bolts are not magnetic S55 | GS7D36SG | M8 | Jointing torque Angle of rotation | 8 Nm 90° |
| 2AZ Oil filler plug | GS7D36SG | Replace screw | 25±3 Nm | |
| 3AZ Oil drain plug | GS7D36SG | Replace screw | 8 Nm | |
| 4AZ Transmission oil sump | GS7D36SG | 10±1 Nm | ||
| 5AZ Nut, sealing cap for oil filler neck | GS7D36SG | Replace gasket | 25 Nm | |
| 6AZ Banjo bolt for oil filler neck | GS7D36SG | Replace seals | 40 Nm | |
| 7AZ Parking lock module | GS7D36SG | M6 | 8 Nm | |
| 8AZ Heat shield, twin-clutch gearbox connector at transmission | GS7D36SG | M6 | 8 Nm |