Mounting the propeller shaft and center mount

NOTE: TECHNICAL INFORMATION
The centering must be checked for damage and lubricated before the prop shaft is installed. Replace damaged centering.
For additional information see:
REMOVING AND INSTALLING/REPLACING FRONT CENTERING FOR PROPELLER SHAFT

Courtesy of BMW OF NORTH AMERICA, INC.

Check centering (1) for damage; replace if necessary.
Grease centering (1).
NOTE: TECHNICAL INFORMATION
When assembling, it is essential to observe screwing sequences and tightening torques.
Failure to comply with the regulations can lead to leaks and damage.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Compliance with the following instructions is required to avoid a humming from the prop shaft after refitting the prop shaft.
Make sure that when the propeller shaft Is Installed, the three-hole flange (3) Is re-assembled with the flexible disc (2) on the specified level.
Replace the screws (1) and nuts.
Parts: Bolts, nuts
Hand-tighten the bolts (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.
Mount the center mount and apply the bolts (1) hand-tight.
Secure the propeller shaft on the center universal joint with a suitable tool (2) to protect it from twisting.

Courtesy of BMW OF NORTH AMERICA, INC.
Secure the special tool (angle of rotation ) 0 490 504 (00 9 120) with the special tool (magnet) 0 495 108 (00 9 130 )to the vehicle underbody .
When tightening the bolt for the flexible disc, use the nut for counter support and tighten with the bolt.

Tighten screws of the propeller shaft.

TIGHTENING TORQUE SPECIFICATIONS

Front flexible disc to prop shaft
M12 Replace screws. Joining torque and angle rotation must be adhered to. Tightening via screw.	Joining torque	55 Nm
	Angle of rotation	90°

Courtesy of BMW OF NORTH AMERICA, INC.

Center mount to body
M8	19 Nm