Remounting the control unit for the Frontal Light Electronics Left (FLEL) and Frontal Light Electronics Right (FLER)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Remove the Front Light Electronics control unit
- Loosen screws (1) .
- Pull the Front Light Electronics (2)
control unit out of the headlights.
- Unlock and disconnect connector (1) .
- Remove the Front Light Electronics (2)
control unit.
Install the Front Light Electronics control unit
- Check the seal (3) on the control unit for the Front Light Electronics (2) for damage and replace if necessary.
- Connect connectors (1)
and lock.
- Position the control unit for the front light electronics (2) in the headlight.
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Frontal Light Electronics (FLE) PT-SCREW 40x12 tightening torque 1.5 Nm