Remounting the LED module for the right cornering light
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to REMOVING THE HOOD SEAL AT THE SIDE ON THE LEFT AND RIGHT .
- Refer to REMOVING THE SEAL FOR THE FRONT CENTER HOOD .
- Refer to PARTIALLY REMOVING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
- Refer to PARTIALLY REMOVING THE WHEEL ARCH COVER ON THE FRONT LEFT AND RIGHT .
- Refer to REMOVING TEMPERATURE SENSOR .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING RIGHT HEADLIGHT .
NOTE:
Description is for left component only. Procedure on the right side is identical.
Removing LED module for the cornering light
- Loosen screws (1) on the LED module for the cornering light (2) .
- Pull LED module for the cornering light (2)
out of the headlight.
- Unlock and disconnect connector (1) .
- Remove LED module for the cornering light (2)
.
Installing the LED module for the cornering light
- Check seal (3)
on the LED module for cornering light (2)
for damage and replace it if necessary.
The seal (3) may not be damaged or be missing.
- Connect connectors (1)
and lock.
- Position the LED module for cornering light (2) in the headlight.
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
LED cornering light module to headlight Screw Tightening torque 1.6 Nm