Replacing rear ride height sensor (X2 2018-2023)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Removal:
Disconnect plug connection (1).
Release nut (4) and detach jointed rod from sensor lever.
Release screw (2).
Remove ride height sensor (3).
Release screws (1).
Take off holder (2).
Installation:
Position holder (2) on ride height sensor.
Tighten down screws (1).
Tightening torque 37 14 1AZ .
Position ride height sensor (3) with holder on rear axle support.
Tighten screw (2).
Tightening torque 37 14 3AZ .
Connect plug connection (1).
Attach jointed rod to sensor lever.
Tighten nut (4).
Tightening torque 37 14 4AZ .
Required follow-up work:
- Check HEADLIGHT ADJUSTMENT , correct if necessary.