Installing the fresh air/recirculated air flap motor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Position the fresh air/recirculated air flap motor with the bracket (2) correctly.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Heater/air conditioner Screw tightening torque 1.2 Nm - Connect and lock corresponding connectors.
Follow-up work
- Refer to INSTALLING RIGHT FOOTWELL VENTILATION DUCT .
- Refer to INSTALLING THE BOTTOM RIGHT INSTRUMENT PANEL TRIM .
- Refer to ADDRESSING THE CONTROLLER DRIVE .