Install the backrest cover of the rear seat backrest

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Place the backrest cover onto the upholstery.
Secure all trim wires in the marked area on the cushion with the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the clamps (2).
Parts: Clamps
Insert the clamp (2) with the special tool 0 492 668 (52 0 050) .
Surround the trim wire (3) of the cushion (1) and the trim wire (4) of the backrest cover (5) with the clamp (2) and bend the clamp (2) to close it.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure that the cushion (1) rests flush on the backrest frame at the marked location.
Position the cushion (1) including cover (2) from the top in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the cushion (1) at the marked location.
Feed in the backrest cover (2) in the bottom area toward the rear in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE REAR PANEL OF THE LEFT REAR SEAT BACKREST .
Refer to INSTALLING THE GUIDE SLEEVE FOR THE REAR HEAD RESTRAINT .
Refer to INSTALLING THE HEAD RESTRAINT .