When replacing the seat frame: Remount components

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Removing the seat-position sensor on the front seat

Release cable tie (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock the connectors in the sequence (1) to (4) and pull them out of the connector housing (5) one after the other in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.
Detach the cable bracket (1) from the seat mechanism.
Put the cable (2) to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1).
Guide the seat-position sensor (2) upward from the seat mechanism (3) and remove it.

Courtesy of BMW OF NORTH AMERICA, INC.

Removing the magnet for the seating position on the front seat
Release the blind rivet (1).
Unclip the magnet (2) for the seating position from the top of the seat mechanism (3) and remove it.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the magnet for the seating position on the front seat
Correctly position the magnet (2) for the seating position and clip it in at the top of the seat mechanism (3).
Fasten blind rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Install the seat position sensor on the front seat
Guide in and correctly position the seat position sensor (2) from above on the seat mechanism (3).

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Sensor on seat mechanism
Screw	tightening torque	1.3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Correctly position the cable (2).
Fasten the cable bracket (1) on the seat mechanism.

Courtesy of BMW OF NORTH AMERICA, INC.
Correctly insert and lock the connector plugs one after another in the order (1) to (4) in the direction of the arrow in the connector plug housing (5).

Courtesy of BMW OF NORTH AMERICA, INC.
Secure cable tie (1).

Courtesy of BMW OF NORTH AMERICA, INC.