Remove front seat

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work

Refer to REMOVING THE FRONT STRAP FITTING .

WARNING: Pyrotechnic components .
Danger! Immobilization period-threatening injuries!

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .

NOTE: TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.

Adjust the front seat fully to the rear.
Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Adjust the front seat fully to the front.
Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnecting all battery ground leads
See DISCONNECTING THE NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .

Courtesy of BMW OF NORTH AMERICA, INC.
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
- Protect working area.
- Handle tools and components carefully.
Courtesy of BMW OF NORTH AMERICA, INC.
Cover the door sill using protective covers.
Place the front seat fully to the rear and disconnect the plug connector (1).
NOTE:
RISK OF DAMAGE
Heavy component .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
Remove the front seat with the assistance of an support person.
For continuing work on the front seat: Mount the front seat on the universal seat mount and connect with the wiring harness if necessary

NOTE: TECHNICAL INFORMATION
Use of the universal seat mount is recommended for carrying out expert repairs.
Fit special tool 2 473 334 onto special tool 0 495 187 (00 2 300) .
CAUTION:
Heavy component .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
Courtesy of BMW OF NORTH AMERICA, INC.
Mount the front seat onto the special tool 2 473 334 .
To ensure a professional repair, it is recommended to use the special tool 0 495 187 (00 2 300) and 2 473 334

NOTE: TECHNICAL INFORMATION
Only use the following steps if the front seat has to be adjusted electrically.
In order to adjust the front seat in a removed state, connect the special tool 0 496 519 (61 4 150) with the vehicle wiring harness and the removed front seat.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect special tool 0 496 519 (61 4 150) to the wiring harness of the vehicle and the removed front seat to adjust the front seat.

Courtesy of BMW OF NORTH AMERICA, INC.