Installing exchange gearbox (AISIN F22AW) (X2 sDrive 28i 2018-2023)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Attention!

Transmissions are filled with fluid. Oil level does not have to be compensated!

Only in the event of discernible external damage to exchange transmission or discernible oil leakage from exchange transmission - check OIL LEVEL .

After completing work:

Only use the APPROVED automatic transmission fluid.
Reset adaptation values.
Perform clutch and gear ratio adaptation.

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Recycling:

Catch and dispose of escaping transmission oil.

Observe country-specific waste disposal regulations

Necessary preliminary tasks:

Refer to REMOVING AUTOMATIC TRANSMISSION (without wheel alignment!) .

Remount the following parts.

Converter, transportation retainer (1).
Remount the gear selector cable holder

Courtesy of BMW OF NORTH AMERICA, INC.

Attention!

In the case of a transmission exchange, the associated heat exchanger for heating system/transmission oil cooler must always be replaced as well.

Failure to comply with this instruction may result in serious damage to the automatic transmission.

Required follow-up work:

Refer to INSTALLING AUTOMATIC TRANSMISSION (without wheel alignment!) .