Remove the rubber mounts for the transmission bearing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to BRINGING FRONT COMPARTMENT LID IN THE SERVICE POSITION .
- Refer to REMOVING SUSPENSION CROSS-BRACE .
- Refer to REMOVING REAR HOOD SEAL .
- Refer to REMOVING FRONT WINDSHIELD PANEL COVER .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE INTAKE MANIFOLD FOR INTAKE SILENCER HOUSING .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to DISCONNECTING CABLE FROM BATTERY EARTH LEAD .
- Refer to REMOVING THE SYSTEM BATTERY .
- Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to REMOVING BATTERY CARRIER .
- Refer to INSTALLING THE ENGINE BRIDGE .
- Refer to REMOVING THE FRONT WHEEL ARCH TRIM .
- Refer to REMOVING THE WHEEL .
- Refer to REMOVING FRONT WHEEL ARCH COVER .
- Loosen screws (1).
- Release the partition wall (2) for the battery from the bracket and remove.
- Detach the control unit (3) from of the bracket.
- Detach the wiring harness (4) from the battery tray (5).
- Remove the battery tray (5).
- Loosen screws (2).
- Loosen screws (1).
- Unscrew the bolt (1) in the wheel arch.
- Remove transmission mount.