26 11 090 Removing and installing/replacing centring mount for propeller shaft (X2 sDrive 28i 2018-2023)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

2 450 247
11 2 030
00 5 500

Necessary preliminary work:

Remove PROPELLER SHAFT .

Removal:

Use the special tool 2 450 247 to remove the centring bearing.

G12702621

Courtesy of BMW OF NORTH AMERICA, INC.

Join pin (1) and pin (2) of special tool 2 450 247 into the centring bearing of the propeller shaft.

Twist pin (1) 90° to pin (2).

G12702622

Courtesy of BMW OF NORTH AMERICA, INC.

Twist pin (2) between pin (1) and (3) of the special tool 2 450 247 into the centring bearing of the propeller shaft.

Twist pin (2) by 90°.

G12702623

Courtesy of BMW OF NORTH AMERICA, INC.

Lock special tool 2 450 247 by twisting the sleeve (1).

Pins (2) are locked with sleeve (1).

G12702624

Courtesy of BMW OF NORTH AMERICA, INC.

Install guide sleeve (1).

Screw spindle (3) with special tool 2 450 247 (2) and support on the guide sleeve (1).

G12702625

Courtesy of BMW OF NORTH AMERICA, INC.

Rotate nut (1) in direction of arrow and pull out of the centring bearing.

G12702626

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Remove grease from centring bore.

Drive centring into propeller shaft with special tools 11 2 030 and 00 5 500 (observe protrusion).

Attention!

Plastic centring mount must not be greased.

G12887961

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Observe protrusion A = 6 mm of centring (1).

G11107063

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install PROPELLER SHAFT .