Install brake light switch
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Clip in the holder (3) of the brake light switch (2) in the brake pedal.
- Press brake pedal.
- Push the brake light switch (2) up to the limit position against the direction of arrow in the holder (3) of the brake light switch (2).
- Hold up the holder (3) of the brake light switch (2) and simultaneously retract the brake pedal slowly in the initial position.
- Slowly pull brake pedal back to limit position.
- Connect connectors (1) and lock.
- Position the air duct (2) and tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Footwell ventilation duct Screw Tightening torque 2.4 Nm
Follow-up work
- Refer to INSTALLING THE FOOTWELL TRIM ON THE BOTTOM LEFT .
- Refer to INSTALLING THE LEFT FOLD-DOWN COMPARTMENT .