Install windscreen
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare the glue cartridge with the standard nozzle C.
- Apply bead joint in area (1) .
- Apply adhesive bead within the mark on the windscreen.
Cut A-A B-B C-C a = Position of the adhesive bead 2 ± 2 mm 3 ± 2 mm 2 ± 2 mm b= Width of adhesive bead 8 ± 1 mm 8 ± 1 mm 8 ± 1 mm h = Height of adhesive bead 12 ± 1 mm 12 ± 1 mm 12 ± 1 mm - Adhere to the geometry of the adhesive bead to make sure that one glue cartridge is sufficient for the complete windscreen.
- Carefully perform the following operations on the windscreen (1) with suction lifter:
- Measure short length (A) of the windscreen (1) to the roof outer skin (2) with special tool 0 495 259 (51 0 010) .
- Adjust short length (A)
.TECHNICAL DATA SPECIFICATION
Gap dimension of windscreen to the body Short length A 2.5 mm... 4.5 mm - Position the windscreen (1) in such a way that the rubber frame (3) lies even and parallel to the roof outer skin (2) .
Follow-up work
- Refer to INSTALLING THE LEFT AND RIGHT A-PILLAR TRIM PANELS .
- Refer to CONNECTING CONNECTOR TO THE RAIN-LIGHT-SOLAR-CONDENSATION SENSOR .
- Refer to INSTALLING THE KAFAS CAMERA .
- Refer to INSTALLING THE INTERIOR MIRROR .
- Refer to INSTALLING THE COVER ON THE INSIDE MIRROR .
- Refer to INSTALLING THE REAR COWL PANEL .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE GUTTER STRIP ON THE WINDSCREEN ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to CALIBRATE KAFAS CAMERA .