Remove the lower right deformation element

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work

Refer to REMOVING THE HOOD SEAL AT THE SIDE ON THE LEFT AND RIGHT .
Refer to REMOVING THE SEAL FOR THE FRONT CENTER HOOD .
Refer to PARTIALLY REMOVING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
Refer to PARTIALLY REMOVING THE WHEEL ARCH COVER ON THE FRONT LEFT AND RIGHT .
Refer to REMOVING TEMPERATURE SENSOR .
Refer to REMOVING FRONT BUMPER COVER .
Refer to REMOVING THE SUPPORT FOR THE LOWER FRONT BUMPER PANEL .

Loosen screws (1).
Detach the washer fluid reservoir (2) from the holder (3).
Set the washer fluid reservoir (2) slightly to the side,

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1), (2) and (3).
Remove the deformation element (4).

Courtesy of BMW OF NORTH AMERICA, INC.