Install the lower left deformation element
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the deformation element (4) .
- Tighten down screws (3)
.TIGHTENING TORQUE SPECIFICATIONS
Deformation element to front axle support adapter screw Tightening torque 11.8 Nm - Tighten down screws (2)
.TIGHTENING TORQUE SPECIFICATIONS
Vertical strut to deformation element Flat-head screw M6x20 Tightening torque 11.8 Nm Hexagon screw Tightening torque 11.8 Nm - Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Air duct to deformation element, bottom M6x20 screw Replace screws Tightening torque 8 Nm
Follow-up work
- Refer to INSTALLING THE SUPPORT FOR THE LOWER FRONT BUMPER PANEL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING FRONT LEFT AND RIGHT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT CENTER HOOD SEAL .
- Refer to INSTALLING HOOD SEAL ON LEFT AND RIGHT SIDES .