Removing the engine from the automatic transmission
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Damage to the engine .
If the engine is manually rotated in the wrong direction of rotation, the engine can be damaged .
Damage to the engine .
If the engine is manually rotated in the wrong direction of rotation, the engine can be damaged .
- Only rotate the engine manually in the correct direction of rotation: a) clockwise when looking at the damper, or b) counterclockwise when looking at the chain drive. b) applies only if the timing chain is installed in the rear.
- Crank engine with special tool 0 493 380 (11 6 480) at vibration damper in direction of rotation.
- Loosen nuts (1) of the torque converter.
- Crank engine further and release remaining 5 nuts.
- Remove screws (arrows).
- Push tabletop (B)
in the direction of the arrow and push automatic transmission (1)
to the side.
- Insert and position the special tool 2 459 012 on the cylinder head.
- Tighten the screws (1)
of the special tool 2 459 012
.TIGHTENING TORQUE SPECIFICATIONS
Special tool to cylinder head M8 Tightening torque 21.5 Nm - Attach the workshop crane with the special tool 0 490 579 (11 0 070) and raise the engine (1) from the lifting table.