Installing engine on automatic transmission
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure that the hole (1) of the flywheel is flush with the dowel hole on the crankcase.
- Check the fitting sleeves (2) for a correct fit and damage, replace if necessary.
- Replace damaged lining sleeves (2)
.
- Position the engine (1) with a workshop crane and position the special tool 0 490 579 (11 0 070) on the special tool 2 184 136 .
- Guide out the workshop crane with the special tool 0 490 579 (11 0 070) from the engine (1) and move it
aside.
- Push table top (B)
in the arrow direction toward table top (A)
and position the automatic transmission (1)
on the engine.
- Turn the torque converter until the bore of the torque converter is aligned with the bore of the flywheel.
- Flange-mount the automatic transmission to the engine.
- Tighten screws (arrows).TIGHTENING TORQUE SPECIFICATIONS
Transmission to engine M8 Tightening torque 19 Nm M12 Tightening torque 66 Nm NOTE: RISK OF DAMAGE
Damage to the engine .
If the engine is manually rotated in the wrong direction of rotation, the engine can be damaged .- Only rotate the engine manually in the correct direction of rotation: a) clockwise when looking at the damper, or b) counterclockwise when looking at the chain drive. b) applies only if the timing chain is installed in the rear.
- Turn the engine with the special tool 0 493 380 (11 6 480)
at the vibration damper in the direction of rotation
.
- Replace nuts (1)
.
Parts: Nuts
- Screw 6 nuts (1)
on the torque converter.TIGHTENING TORQUE SPECIFICATIONS
Torque converter to flywheel M10
Replace nuts.
Remove any adhesive residue from the thread, if necessary.tightening torque 56 Nm - Unscrew the bolts (1) of the special tool 2 459 012 .
- Guide the special tool 2 459 012 out and remove.