Connecting the bleeder unit for the brake fluid

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Removing rear hood seal

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Pull off the hood seal (1) towards the top and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Removing front windshield panel cover

Loosen the expanding rivet (1) .
Guide the front fairing panel cover (2) out of the rear fairing panel cover (3) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

The following procedure must be carried out to ensure that the brake system is bled correctly!
Fill new brake fluid in the expansion tank up to the lower edge of thread (1) .
Bleed the hose of the bleeder unit before connecting.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Use only BMW-approved brake fluids; see "Fluid Capacities" tab for the selected vehicle.
NOTE:
RISK OF DAMAGE
Paint damage .
Mechanical or chemical action may lead to paint damage .
- Cover up working area with specified covering material only.
Courtesy of BMW OF NORTH AMERICA, INC.
Connect the bleeder unit (1) to the brake fluid expansion tank and switch it on.
Observe the operating instructions of the corresponding equipment manufacturer.
Do not exceed the filling pressure of 2 bar .