Brake test on the rear axle on the brake test stand
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Position the vehicle with its rear axle on the brake test stand.
- Position the selector lever in selector lever position N (neutral).
- The brake test stand starts automatically.
The control unit runs a plausibility check (comparison of wheel speed) to identify within a few seconds that a vehicle is on the brake test stand and changes to brake test stand mode.
If brake test stand mode has been activated and the EMF actuators are open, the indicator light for the electromechanical parking brake (EMF) flashes slowly.
- Press brake pedal.
- Read the maximum brake forces on the left and right.