Install the charging pressure sensor on the throttle body
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Prior to installation, apply a thin coat of lubricant to the sealing ring (1) of the charging pressure sensor.
- Insert and install the boost pressure sensor (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Boost pressure sensor to throttle body | ||
|---|---|---|
| TS5x20 | tightening torque | 5 Nm |
Follow-up work
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .