Installing the gas pressure spring for engine compartment lid

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
The notes on the disassembly and installation of ball sockets with clamps are the basis for these repair instructions and must be observed without fail.
For additional information see: REMOVING/INSTALLING BALL SOCKETS WITH CLIP .

NOTE: Description is for left component only. Procedure on the right side is identical.

Position the gas pressure spring for hood (2) .
Set the gas pressure spring for hood (2) on the ball head and engage at the locking springs (1) .

Courtesy of BMW OF NORTH AMERICA, INC.