Replacing left or right tie rod end (X2 2018-2023)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the tie rod end to tie rod screw connection is released, it is necessary after reinstallation to carry out a chassis/wheel alignment check.
Necessary preliminary tasks:
- Refer to REMOVING FRONT WHEEL .
Removal:
Slacken nut (1).
Release tie rod (2) from swivel bearing.
Mark thread depth of tie rod end to simplify subsequent adjustment of front axle.
Release screw (1).
Unscrew tie rod end (2).
- Counterhold tie rod with open-end spanner if necessary.
Installation:
Check GAITER for damage and replace if necessary.
Screw tie rod end onto tie rod up to marking.
- Counterhold tie rod with open-end spanner if necessary.
Tighten screw (1).
Tightening torque 32 21 2AZ .
Keep tie rod end to swivel bearing connection clean and free from oil and grease.
Insert tie rod (2) into swivel bearing.
Part: Replace nut (1).
Tighten nut (1).
Tightening torque 32 21 1AZ .
Required follow-up work:
- Refer to INSTALLING FRONT WHEEL .
- Refer to CARRYING OUT WHEEL ALIGNMENT PROCEDURE .