CBS reset (X2 2018-2023)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The CBS maintenance jobs can be reset in the car. It is always recommended to reset the CBS jobs via the diagnosis system.
It is only possible to code the country-specific statutory intervals with the diagnosis system.
Front/rear brake service:
A CBS reset is only possible in the vehicle with a sanded brake pad wear sensor (CBS display in CID active).
A CBS reset is only possible with the diagnosis system with a non-sanded brake pad wear sensor (no CBS display in CID).
Other known causes of CBS reset problems:
It is only possible to code the country-specific statutory intervals with the diagnosis system.
Front/rear brake service:
A CBS reset is only possible in the vehicle with a sanded brake pad wear sensor (CBS display in CID active).
A CBS reset is only possible with the diagnosis system with a non-sanded brake pad wear sensor (no CBS display in CID).
Other known causes of CBS reset problems:
- Parking brake engaged
- Brake pedal pressed
CBS reset with diagnosis system
NOTE:
To be able to check or correct the vehicle's on-board date properly, the diagnosis system requires the correctly set tester system date!
The jobs may only be reset after the service measure has been completed.
The CBS jobs can be reset via the diagnosis system on the following path:
The jobs may only be reset after the service measure has been completed.
The CBS jobs can be reset via the diagnosis system on the following path:
- Service functions
- Maintenance
- CBS reset
CBS reset in the car
On the vehicle, service operations can be reset at the instrument panel.
NOTE:
On-board date must be correctly set.
A reset is only possible in the car if:
Resetting of a service job must always be carried out after a maintenance measure has been completed.
The resetting process is interrupted it the time is exceeded or if a terminal is changed.
A reset is only possible in the car if:
- no CC message is present
- availability of the service job is under 90 %
Resetting of a service job must always be carried out after a maintenance measure has been completed.
The resetting process is interrupted it the time is exceeded or if a terminal is changed.
- Switch the ignition on.
- Press the trip distance recorder reset button (1) (referred to as button in the following) for approx. 10 seconds until the 1st service job is displayed in the display (2).
Bring up the next item by briefly pressing the button again. Select the desired service job.
- If a reset is possible, this is displayed in the instrument cluster as "Reset possible".
Press the button for 3 s to start the reset.
- Confirm text message "Perform reset?" by pressing the button for 3 seconds again.
The status of the reset is indicated in the display by a progress bar and reads "Reset in progress".
- The reset is confirmed as "Reset successful" after completion.
CBS reset of inspections/tests required by law
Input the target date for the statutory vehicle inspection by clicking on the scope of maintenance work with the controller in the CBS main menu of the Central Information Display under: