1112 CYLINDER HEAD (M240i and M240i xDrive coupe/convertible)

1112 TIGHTENING TORQUE OVERVIEW

Cylinder head cover to cylinder head
M6x27	1. Joining torque	8 Nm
M6x27	2. Tightening torque	11 Nm
Cylinder head on device
M10X90x1.5	Tightening torque	30 Nm
Cylinder head on the special tool (press-out plate)
	Tightening torque	35 Nm
Cylinder head to crankcase/timing case cover
M8x40 Replace screws.	Tightening torque	19 Nm
Cylinder head to crankcase (cylinder head bolt)
M11 x 188 13.9, screw head height 13 mm. Replace screws.	1. Joining torque	30 Nm
	2. Joining torque	50 Nm
	3. Angle of rotation	90°
	4. Angle of rotation	90°
	5. Angle of rotation	90°
	6. Angle of rotation	90°
M11 x 188 11.9, screw head height 11 mm. Replace screws.	1. Joining torque	30 Nm
	2. Angle of rotation	90°
	3. Angle of rotation	90°
	4. Angle of rotation	90°
Cylinder head to special tool 2 361 215
Tightening torque		35 Nm
Flange to assembly jig
M14X30	Tightening torque	135 Nm
Front lifting eye on the cylinder head
M8x22	Tightening torque	19 Nm
Heat shield to cylinder head
M8x12 Replace screws.	Tightening torque	19 Nm
Special tool 00 2 320 to special tool 00 2 300
M14X95	Tightening torque	130 Nm
Special tool 2 456 190 to cylinder head
M6X20	Tightening torque	8 Nm
Venting connector/special tool to cylinder head
M10 Replace the venting connector!	Tightening torque	18 Nm
Venting connector/special tool to cylinder head
M10	Tightening torque	18 Nm