Installing the crankshaft sensor
- Feed in and install the crankshaft sensor (3).
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Crankshaft sensor to crankcase | ||
| TS5x20 | tightening torque | 4.6 Nm |
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
Follow-up work
- Refer to INSTALLING THE PROTECTIVE PLATE FOR THE FUEL LINES .
- Refer to INSTALLING THE SUPPORT FOR THE UNDERBODY PROTECTION .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .