Removing and installing or replacing flat motor for front left or right power window regulator (2016-2022)

Necessary preliminary tasks:

Unlock and disconnect the connector (1).

Release nuts at marked points.

Tightening torque 51 33 2AZ .

Feed out flat motor (2).

Installation note:

Make sure flat motor (2) is correctly fitted in guide (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 33 1AZ .

Remove flat motor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure drive shaft (2) is correctly seated in mounting (1) at power windows (3).

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

An initialization must be carried out in order to activate anti-trap mechanism.

OBSERVE information on initializing power window regulator.