Install all ignition coils
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
Install ignition coil
- Install ignition coil (3) .
- Tighten down screw (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Ignition coil | ||
|---|---|---|
| screw | Tightening torque | 8 Nm |
- Connect connectors (1)
and lock.
The connector (1) must engage audibly.
- Mount the connector (1) of the Lambda oxygen sensor and the oxygen sensor monitor on the cable duct (2) .
Follow-up work