Install the VANOS central valve 1-4 for the exhaust
- Position the exhaust cam phaser (2) .
- Hand-tighten the VANOS central valve (1)
of the exhaust cam phaser (2)
.
Follow-up work
- Refer to ADJUSTING THE TIMING FOR CYLINDER 1 TO 4 (CYLINDER HEAD REMOVED) .
- Refer to REPLACING THE O-RING FOR VACUUM PUMP CYLINDERS 1 THROUGH 4 .
- Refer to REPLACING THE CYLINDER HEAD COVER GASKET .
- Refer to FASTENING CYLINDER HEAD COVER OF CYLINDERS 1 TO 4 .
- Refer to CYLINDER HEAD COVER SCREW CONNECTION AT CYLINDERS 1 TO 4 WITH IMPAIRED ACCESSIBILITY .
- Refer to INSTALLING THE HEAT SHIELD AT THE RIGHT CYLINDER HEAD COVER CYLINDERS 1 TO 4 .
- Refer to INSTALLING HEAT SHIELD OF THE HIGH PRESSURE PUMP OF CYLINDER HEAD COVER AT LEFT FOR CYLINDERS 5 TO 8 .
- Refer to INSTALLING RIGHT HIGH PRESSURE PUMP .
- Refer to INSTALLING INJECTORS .
- Refer to INSTALLING FUEL DELIVERY LINE .
- Refer to INSTALLING ALL IGNITION COILS ON THE RIGHT .
- Refer to INSTALLING THE CATALYTIC CONVERTER FOR CYLINDERS 1 TO 4 .
- Refer to REMOVING THE CATALYTIC CONVERTER FOR CYLINDERS 5 TO 8 .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING THE REAR AXLE COVER .
- Refer to REPLACING THE O-RING OF THE VACUUM PUMP .
- Refer to ALIGNING THE VACUUM PUMP FOR THE CAMSHAFT .
- Refer to INSTALLING THE VACUUM PUMP .
- Refer to SECURING THE WIRING HARNESS ON THE CYLINDER HEAD COVER ON THE RIGHT .
- Refer to INSTALLING THE RIGHT-HAND CHARGE AIR COOLER .
- Refer to INSTALLING RIGHT CLEAN AIR PIPE .
- Refer to INSTALL ENGINE VENTILATION LINE .
- Refer to INSTALLING THE RIGHT UNFILTERED-AIR DUCT .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to FILLING THE COOLING SYSTEM WITH THE VACUUM FILLING UNIT .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .