Installing front brake caliper (17-inch Low brake)

• Fit and tighten brake hose (1)  on brake caliper.

  If necessary, grip at knurling (2)  .

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Brake hose to brake caliper, front
  	tightening torque	17 Nm

• Make sure the brake hose is not  twisted and resting on components attached to the body.
• If required, attach brake hose to the holder (3)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to GREASE THE BRAKE PADS, THE BRAKE ANCHOR PLATE AND THE BRAKE CALIPER WITH THE BRAKE PAD PASTE (17-INCH LOW BRAKE) .
• Refer to INSTALLING FRONT BRAKE PADS (17-INCH LOW BRAKE) .
• Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
• Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (HIGH BRAKE) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to COMMISSIONING/BEDDING IN (BRAKE) NEW BRAKE PADS AND BRAKE DISCS .