Installing the wiring harness section of the blow-off valve for cylinders 1-4

• Feed in the wiring harness section and position it.
• Connect connectors (1)  and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the wiring harness section in the guide.
• Lock the guide of the wiring harness section in the area (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (2)  and lock.
• Clip in the wiring harness section in the area (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING CLEAN AIR PIPE OF CYLINDER BANK 1 .
• Refer to CONNECTING THE RIGHT CHARGE AIR LINE TO THE TURBOCHARGER .
• Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING WITH THE RIGHT FRONT-END STRUT .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
• Refer to INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .